Port issues with Lemur

Homepage Forums Support PULL support Port issues with Lemur

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #3854
    derek
    Participant

    I cannot seem to make lemur run on port 8004. its stuck at 8000 and i dont know how to change it. i am only getting one way communication from ableton-ipad. I read the manual but it said they must be on same port

    #3855
    xmonsta
    Keymaster

    Hi Derek,

    The port on the left hand side of your Lemur settings show your iPad IP/Port – this is uneditable.

    The IP/Port should be entered into the field “OSC Target” (The IP field is right next to it – in the middle of the screen and the port on the right hand side of the screen).

    Here is an example: http://www.xmonsta.com/wp-content/uploads/2014/10/LemurSettings.png

    The areas in red are where your IP/Port should go. We will add this to the manual shortly.

    Cheers

    Xmonsta

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.