Using PULL with MidiMux

Homepage Forums Support PULL support Using PULL with MidiMux

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #4558

    Hi xmonsta.
    I’m researching PULL while traveling and have used Lemur/TouchOSC previously. I found the ad-hoc networking a bit tedious and think I would prefer a cabled solution to a wireless one. Recently learned about the StudioMux bundle (and MidiMux specifically). Have you tested PULL with Midimux? My hunch is that it will work fine but wanted to check before purchasing the bundle.



    Confirming that MidiMux seems to work fine.


    Hey Syncr, sorry for the slow response. We get most queries through our support email and reply a bit quicker there.

    PULL uses OSC for most of it’s communication over a network. The only parts that are midi are parts of the impulse and drum instrument templates. We’re looking into sending OSC data as SYSEX information over a MIDI connection, so all of PULL information can be sent over MIDI (which could then use a cable, or midimux, or any midi over network (USB)). However, we’re some way from making this happen at the moment.

    From all our tests, Lemur is extremely fast and stable over wifi though. If you record a parameter and look at the resolution you get from the recorded automation you can see there is virtually no dropout, or shakiness, like you get in other controllers over wifi.



Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.